Adjusting The Stand Height - LG 24MB56HQ-B Owner's Manual

WARNING
To avoid injury to the fingers when adjusting
y
the screen, do not hold the lower part of the
monitor's frame as illustrated below.
Do not touch or press the screen when
adjusting the angle of the monitor.
Do not hold this set like below picture.Monitor
screen can detach from stand base and injure
your body.
NOTE
Tilt from +20 to -5 degrees up or down to adjust
the angle of the Monitor set to suit your view.
Front

Adjusting the stand height

1
2
3
Rear
ASSEMBLING AND PREPARING
Place the monitor mounted on the stand base
in an upright position.
Remove the tape attached at the bottom rear
of the stand body, then pull out the locking
pin.
Stand Body
Locking Pin
The height can be adjusted up to 110 mm.
CAUTION
Once the pin is removed, it is not necessary
y
to re-insert it to adjust the height.
WARNING
Do not put your finger be-
y
tween the screen and the
base (chassis) when adjust-
ing the screen's height.
9
Tape
110.0mm