Advertisement
Disassembly Instructions
- Before disassembly, the POWER SWITCH must be set to the OFF position and the power cord
disconnected.
1. Remove the front grille.
2. To remove the front grille, pull out the bottom of
the front grille and then lift up.
3. Re-install the cover by placeing the front grille
over the tabs on the top of the unit and push
the bottom of the front grille until the clips snap
into place.
• This Room Air Conditioner (PTAC) discharges
air from the top of the unit through reversible, 2-
position discharge grille louvers. The unit is
shipped from the factory with the discharge grille
louvers at an angle of 40˚ off vertical. In an
alternate position the louvers will be at an angle
of 15˚ off vertical.
To adjust the air discharge direction, remove the
front grille.
Remove the 4 screws that fasten the discharge
grille to the front grille.
Flip the discharge grille 180°, then reattach the
discharge grille to the front grille with 4 screws.
40˚
15˚
Control Locations
Screws
Owner's Manual 17
Advertisement
