Dab - Panasonic SC-PM602 Operating Instructions Manual

DAB+

Preparation
Press [RADIO] to select "DAB+".
Note:
"DAB+"
If you select for the first time, the system will tune
automatically.
Manual tuning
1
Press [PLAY MENU] repeatedly to select
"MANUAL SCAN".
2
Press [R, T] to select the frequency block and then
press [OK].
If no station is detected, "SCAN FAILED" is shown.
Adjust the antenna and try again.
To tune automatically
1
Press [PLAY MENU] to select "AUTOSCAN" and
then press [OK].
"START?" is shown.
2
Press [OK] to start tuning.
"DAB AUTO SCAN" is shown.
If no station is detected, "SCAN FAILED" is shown.
Do manual tuning.
Note:
Preset frequencies are erased after you do automatic tuning.
Memory presetting
You can preset up to 20 stations.
1
Press [PLAY MENU] repeatedly to select
"TUNE MODE".
2
Press [R, T] to select "STATION" and then press
[OK].
3
Press [2/3] or [5/6] to tune in to the
station.
4
Press [OK].
5
Press [R, T] to select a preset number and then
press [OK].
Do steps 3 through 5 again to preset more stations.
The new station replaces any station that occupies
the same preset number.
Note:
You cannot preset a station when the station is not
broadcasting or when you have selected a secondary service.
█
Selecting a preset station
1
Press [PLAY MENU] repeatedly to select
"TUNE MODE".
2
Press [R, T] to select "PRESET" and then press
[OK].
3
Press [2/3] or [5/6] to select the preset
station.
8
8
Secondary service
You can listen to secondary services when "
shown.
1
Press [PLAY MENU] repeatedly to select
"DAB SECONDARY".
2
Press [R, T] to select the secondary service and
then press [OK].
To cancel, select "PRIMARY".
Note:
The setting is cancelled when you select other stations.
Viewing available information
You can view the following information on the display
panel:
• Information about the DAB broadcast
• Programme type
• Ensemble label
• Frequency
• Time
Press [DISPLAY].
Checking the signal quality
You can check the signal quality when adjusting the
antenna.
1
Press [PLAY MENU] repeatedly to select
"SIGNAL QUALITY" and then press [OK].
The frequency block followed by the reception quality
is shown.
To select other frequency blocks, press [R, T].
Frequency Frequency
block
2
Press [OK] again to exit.
Automatic clock adjustment
You can set the clock to update automatically.
1
Press [PLAY MENU] repeatedly to select
"AUTO CLOCK ADJ".
2
Press [R, T] to select "ON ADJUST" and then press
[OK].
To cancel, select "OFF ADJUST".
" is
Reception quality
0 (poor) to 8 (excellent)