Cycle Guide - Whirlpool WDF590SAJW User Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

■

Pour rinse aid into the opening until the indicator level shows

that it is full.

■

Close dispenser by pushing down gently on the lid.

NOTE: For most water conditions, the factory setting will

give good results.

If you are experiencing poor drying performance, you may

want to try a higher setting. Turn the arrow adjuster to a

higher setting to increase the amount of rinse aid.

Select a Cycle

Efficient dishwashers run longer to save water and energy, just as

driving a car slower saves on gas. Typical cycle time is approximately

2¹⁄₂ hours but can take less or more time to complete, depending

on selections.

Estimated cycle times may increase or decrease, depending on water temperature, soil conditions, dish load size, and options selected.

The most advanced and versatile cycle. This cycle senses load size, soil

amount, and toughness of soil, to adjust the cycle for improved performance,

using only the amount of water and energy needed. Use for all soil levels.

Use for hard-to-clean, heavily soiled pots, pans, casseroles, and tableware.

This cycle with only the Heat Dry option selected, and without other options

selected, is recommended to completely wash and dry a full load of normally

soiled dishes. The energy usage label is based on this cycle and option

combination.

Use for lightly soiled items. It saves energy.

For fast results, 1-Hour Wash will clean dishes using slightly more water and

energy. For improved drying, select the Heat Dry option.

NOTE: Some detergents are not recommended for short wash cycles, please

refer to your detergent packaging for more information.

Full

Add

CYCLE GUIDE

CYCLES

Select Options

You can customize your cycles by pressing the options desired. If you

change your mind, press the option again to turn off the option. Not all

options are available for every cycle. If an invalid option is selected for a

given cycle, the lights will flash. Adding options may increase the cycle

time displayed.

Follow the Progress of Your Dishwasher

The fully lit display will glow for Wash, Drain,

Drying, Sanitized, and Complete. It will also

display the remaining time for the cycle in

hours and minutes.

Select the desired cycle by pressing the

Cycles button. Each time the Cycles button is pressed, the next

available cycle will be displayed.

Start or Resume a Cycle

NOTE: Run hot water at the sink nearest your dishwasher until the

water is hot. Turn off water.

IMPORTANT: If anyone opens the door to add a dish (even during

the Delay Hours option), the START/RESUME button must be pressed

each time.

■

Push door firmly closed within 3 seconds of pressing START/

RESUME. If door is not closed within 3 seconds, the Start/Resume

button LED will flash, an audible tone will be heard, and cycle will

not start.

SOIL LEVEL

All soil levels

Heavy

All soil levels

Light

ESTIMATED

WATER

WASH TIME

USAGE

DISPLAYED*

GALLONS

H:MM W/O

(LITERS)

OPTIONS