Mounting The Anchor Nut And Bolt - LG AVNQ48GM2A0 Installation Manual

Mounting the anchor nut and bolt

- Prepare 4 suspension bolts. (Each bolts
length should be same.)
- Measure and mark the position for the
Suspension bolts and the piping hole.
- Drill the hole for anchor nut on the ceiling.
- Insert the nuts and washer onto the suspen-
sion bolts for locking the suspension bolts on
the ceiling.
- Mount the suspension bolts to the anchor-
nuts firmly.
- Secure the hangers onto the Suspension
bolts (adjust level roughly.) using nuts, wash-
ers and spring washers.
- Adjust a level with a level gauge on the
direction of left-right, back-forth by adjusting
suspension bolts.
- Adjust a level on the direction of top-bottom
by adjusting supension bolts. Then the unit
will be declined to the bottomside so as to
drain well.
VM1 AVNQ36GM1A0
AVNQ48GM2A0
VM2
AVNQ60GM2A0
Anchor nut
Ceiling
Nut
Washer Washer Washer
A
Suspension Suspension Suspension
bolts bolts bolts
(Unit : mm)
A B
1018
355
1418
B
Suspension bolt
Suspension
bolts
Spring
washer
Nut
Hanger
Max.
Washer
12mm
THE INDOOR UNIT INSTALLATION
Hanging bolt
(W3/8 or M10)
Nut
(W3/8 or M10)
Spring washer
(M10)
- The following parts is option.
Hanging Bolt - W 3/8 or M10
Nut - W 3/8 or M10
Spring Washer - M10
Plate Washer - M10
CAUTION
!
Tighten the nut and bolt to prevent unit
from falling
• Drill the piping hole on the wall slightly
tilted to the outdoor side by using a
Ø 70 hole-core drill.
Wall
Indoor
9
Flat washer
for M10
(accessory)
Flat washer
for M10
(accessory)
Nut
(W3/8 or M10)
Outdoor
Slope gradient for
drain Should be
1/50 ~ 1/100