Cable Replacement Kits - Alto-Shaam HALO HEAT ED2-60 Installation Operation & Maintenance

Heated
Table of Contents

Advertisement

P a rt n u mb er s a nd d r aw ings ar e s u bj e c t t o c h a n g e w i t h o u t n o t i c e .
C aB l E r E p l a C EM En t K It
CABLE HEATING SERVICE KIT NO
:
INCLUDES
CB-3045
CABLE HEATING ELEMENT
CR-3226
RING CONNECTOR
BU-3105
SHOULDER BUSHING
BU-3106
............................................................. 8
CUP BUSHING
SL-3063
INSULATING SLEEVE
TA-3540
HIGH TEMPERATURE TAPE
ST-2439
, 10/32 ............................................................. 8
STUD
NU-2215
.................................................................. 32
HEX N UT
c A u T I O N
the performance of this unit has
been optimized using the factory
provided bulbs. these bulbs should
be replaced with an exact replacement
or with a factory recommended
replacement. these bulbs have been
treated to resist breakage and must be
replaced with similarly treated bulbs in
order to maintain compliance with nsf
standards. DO nOt over-tighten bulbs
in their receptacles as this can cause
damage to the bulb fi lament.
D A N G E r
DIScONNEcT uNIT FrOM
POwEr SOurcE bEFOrE
cLEANING Or SErVIcING.
ED2 -60 Operation & C are Manual • 13
.
5009752
...................................122
....................................................... 8
.................................................... 8
..................................................... 8
.....................................1
S E r V I c E
FEET
ROLL

Advertisement

Table of Contents
loading

This manual is also suitable for:

Halo heat ed2sys-60

Table of Contents