Related Manuals for LG LFRF0222S
Summary of Contents for LG LFRF0222S
- Page 1 Installation Manual Electric Range LFRF0222S Please read these instructions thoroughly before installing and operating the range. P/No.: MFL40441501...
-
Page 2: Before You Begin
Part 1 SAFETY BEFORE YOU BEGIN Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range. -
Page 3: Parts Provided
Part 1 SAFETY PREPARE TO INSTALL THE RANGE WARNING TOOLS NEEDED • The information in this manual should be followed exactly. - A fire or electrical shock may result causing property damage, perasonal injury or death. WARNING • DO NOT step or sit on oven door. -
Page 4: Prepare To Install The Range
Part 2 PREPARE TO INSTALL THE RANGE INSTALLATION DRAWINGS NOTE SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. CLEARANCES AND DIMENSIONS (Figure 1) To install range refer to the following Figure 1. For installation in CANADA, a Free-standing range is not to be installed closer than (12mm) from any adjacent surface. -
Page 5: Electrical Connection
Part 3 ELECTRICAL CONNECTIONS ELECTRICAL CONNECTION CONNECT RANGE CORD REQUIREMENTS The Rear Access cover must be removed. Loosen the three screws with a screwdriver. The terminal block This appliance must be installed and grounded on a will then be accessible. branch circuit by a qualified technician in accordance with the National Electrical code ANSI/NFPA NO. - Page 6 Part 3 ELECTRICAL CONNECTIONS 3-wire connection with a power supply cord WARNING • The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main terminal block.
- Page 7 Part 3 ELECTRICAL CONNECTIONS 4-wire connection with a power supply cord 3-wire connection: conduit Install the conduit as follows: WARNING Remove the Conduit connection plate from the rear of drawer body and rotate it as shown in Figure 5. The •...
- Page 8 Part 3 ELECTRICAL CONNECTIONS 4-wire connection: conduit 1. Follow the instructions under “Install the conduit as 4-wire connection follows” on page 7 to correctly install the strain relief. You must install the conduit with a strain relief. 2. Loosen the 2 lower left and right screws from the terminal block.
-
Page 9: Install The Range
Part 4 INSTALL THE RANGE Replace the access cover on the range back. To replace the wire cover, insert double projections in the pockets located below the opening and tighten the three screws. Use a spirit level to check your adjustments. Place the level diagonally on the oven rack, and check each direction for level.