Advertisement
Connector Panel & Interfaces
Antenna
Touchmonitor & Computer Module Connections
1. Once the Computer Module has been installed, connect the AC power cable between the touchmonitor's POWER IN connector and the AC power
source.
a. NOTE: Computer Module can be installed when the AC power cable is connected (Hot pluggable). Do not remove the Computer Module
unless it is completely shut off.
2. Make any desired connections to the Computer Module connector panel.
3. Press the touchmonitor's power button to turn on the Computer Module.
Operating System Setup – Windows 10
The initial setup of the operating system takes approximately five minutes. Additional time might be needed for specifying operating system configurations.
During installation, you will be prompted to enter user information. This can be done via touch and the on screen keyboard or you can connect a USB
mouse and keyboard to fill in the required information.
To set up the Windows 10 OS for the Computer Module, turn on the touchcomputer and follow the instructions on the screen.
User Manual – Elo Computer Module
HDMI
USB x4
Ethernet
Antenna
Line Out / Microphone
UM600337 Rev. D, page 7 of 31
Advertisement
