Advertisement
Recovering the System to factory defaults
If for any reason the touchcomputer's operating system needs to be recovered TO FACTORY SETTINGS, you can recover your system by following
procedures below. PLEASE NOTE THAT ALL CUSTOMER SETTINGS AND DATA WILL BE LOST DURING THIS PROCESS. Please be sure to backup all
data, settings, and customer-installed software before proceeding.
1. Power off your system.
2. Power on your system.
3. Plug in the USB drive (created in the previous section) to the computer module.
4. In case the system is crashed and you have to use the recovery flash drive, reboot the system and press F7 several times to enter Device Boot
Menu. Then, choose "boot from flash drive". When the following UI is presented, click "Install Recovery Solution" button.
5. Follow the on-screen instructions to complete the installation process and then exit the program.
i. Note: All data will be deleted during the recovery process. User should back up files when necessary. Elo Touch Solutions does not accept
liability for lost data or software.
ii. Note: The end user must adhere to Microsoft's Licensing Agreement
User Manual – Elo Computer Module
UM600337 Rev. D, page 14 of 31
Advertisement
