Features At A Glance - Frigidaire FFCD2413UW Use & Care Manual

FEATURES AT A GLANCE

Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms
against soiled surfaces. First, the dishwasher fills with water covering the filter area. Water is
then pumped through the spray arms. Soil particles go through and across the filter and down the
drain as the water is pumped out. This series of steps are repeated as needed. The number of
water fills vary with the cycle being used.
Cup Shelves
Middle Spray Arm
Lower Spray Arm
Overfill Protector
Rinse Aid
Detergent Dispenser
Getting Started
1. Load Dishwasher (See Preparing and
Loading Dishes).
2. Add detergent (See Dishwasher
Dispenser & Detergents).
3. Add Rinse Aid, if needed (See Rinse
Aid).
4. Close door to latch.
5. Select desired CYCLE (See Cycle
Chart). The indicator light above the
will glow when selected.
6. Select desired OPTION (See Energy
Options). The indicator light above the pad
will glow when selected.
7. Run hot water faucet nearest
dishwasher until water is hot. Turn water off.
8. To start, press START/CANCEL pad.
4
Features may vary according to model
Shower Nozzle

The dishwasher is programmed to remember
your last cycle so you do not have to reset
each time. To start the dishwasher using
the same cycle and options selected on the
previous wash, just press the START/CANCEL
pad.
Wash Cycle Selections
pad
Cycle times are approximate and will vary with
options selected. Hot water is necessary to
activate dishwasher detergent and melt fatty
food soils. An automatic sensor will check the
incoming water temperature and, if it is not
hot enough, the cycle will be lengthened for
automatic water heating in the main wash and
final rinse of all cycles. This happens even
when HIGH TEMP WASH option has not be
selected. When HIGH TEMP WASH is selected,
an even higher temperature will be reached to
handle heavier soil loads.
Top Rack
Serial Label
(Located on Right)
Lower Rack
Silverware Basket
NOTE
Glass Trap
Heating Element