Sony SA-G700 Operating Instructions Manual page 37

Items
[BT] [POWER]
(BLUETOOTH (BLUETOOTH
settings) Power)
[STANDBY]
[AAC CODEC]
[SYSTEM] [IR REPEATER]
(System
settings)
[AUTO
STANDBY]
[VERSION]
(Version
information)
[RESET] [ALL RESET]
(Resetting the
system)
[UPDATE] [START]
(Updating the
system)
[CANCEL]
Function
You can turn the BLUETOOTH function on or off.
• [ON]: Turns the BLUETOOTH function on.
• [OFF]: Turns the BLUETOOTH function off.
Note
When the BLUETOOTH function is set to off, the BLUETOOTH
input is skipped while selecting input by pressing INPUT.
When the system has pairing information, you can turn the
system on and listen to music from a BLUETOOTH device,
even when the system is in standby mode, by setting the
BLUETOOTH standby mode to on.
• [ON]: BLUETOOTH standby mode is enabled.
• [OFF]: BLUETOOTH standby mode is disabled.
Note
While the BLUETOOTH standby mode is on, standby power
consumption increases.
You can enjoy high-quality sound if AAC is enabled and your
device supports AAC.
• [ON]: Enables AAC codec.
• [OFF]: Disables AAC codec.
• [ON]: Remote signals for the TV are sent from the rear of
the bar speaker.
• [OFF]: Turns off the function.
For details, see "When the TV Remote Control does not
Work" (page 16).
• [ON]: Turns on the auto standby function. When you do not
operate the system for about 20 minutes, the system
enters standby mode automatically.
• [OFF]: Off.
The current firmware version information of the system
appears in the front panel display.
You can reset the system settings to the factory default. For
details, see "Resetting the System" (page 45).
You can start a software update after connecting the USB
memory on which the software update file is stored to the
system. When there is a software update available, we will
notify you on the following website:
https://www.sony.eu/support
Notes
• Before updating, make sure that the subwoofer is turned
on and connected to the system.
• You can update the software of the system by pressing and
holding  and the BLUETOOTH button on the bar speaker
for 7 seconds.
Returns to the upper layer [UPDATE].
37
GB