Advertisement
TROUBLESHOOTING GUIDE (continued)
SYMPTOM
CAUSE
Jammed nail
Wrong size or angle nails
Magazine screws not secured after
previous jam clear/inspection
Damaged or worn driver blade
Material and fastener length
Debris in nosepiece
Worn magazine
Damaged pusher spring
Dry fire lock out is engaged with only 7-9
nails remaining in magazine and the user
is applying excessive force to contact trip,
overriding the lockout
Tool is not yet run-in
Use of incorrect speed (DCN692 only)
FIX
Use only the recommended nails. Refer to
Technical Data.
Make sure to tighten magazine hex bolts with
wrench provided.
Replace driver blade. See authorised D
repair agent.
If the unit continues to stall (forcing the need to
rotate the Stall release lever) choose the appropriate
material and fastener length that is not too rigorous
an application.
Clean nose area and watch closely for small pieces
of broken nails stuck in the track.
Replace magazine. See authorised D
agent.
Replace spring. See authorised D
agent.
Load more nails in magazine to disengage dryfire
lockout.
New tools can take 500–1000 nails for parts to
mesh and wear in together. Drive shorter nails
during this period if experiencing difficulty driving
nails flush.
If trying to drive longer ring shank nails in soft
woods, or driving ring shank nails into harder
materials in speed 1 - adjust speed setting to
position 2.
EN GL IS H
WALT
E
WALT repair
E
WALT repair
E
63
Advertisement
