Samsung HG32EF690 Installation Manual page 33

USB Cloning
¦
USB Cloning is used to download user-configured settings (Picture, Sound, Input, Channel, Setup, and Hotel Setup) from
one TV set and upload them to other TV sets.
All the user-defined settings from the TV (Master Set) can be copied to the USB device.
✎ After cloning, certain features are applied when the TV is turned on again.
• Clone TV to USB: This copies stored data from the TV set to the USB
device.
1. Insert a USB drive into the USB port on the rear of the TV.
2. Enter the Interactive menu by pressing buttons in order.
• MUTE → 1 → 1 →
3. Press the ▲ or ▼ button to select "Clone TV to USB", then press the
ENTERE button.
4. When the message "Clone TV to USB" is displayed, press the ENTERE
button.
5. You can verify USB cloning behavior.
• In Progress: during copying data to USB.
• Completed: copy was finished successfully.
• Failed: copy was not finished successfully.
• No USB: USB is not connected.
✎ The clone folder will be labeled T-KTMDEUCB.
• Clone USB to TV: This to downloads the stored data in the USB device to
TV set.
1. Insert a USB drive into the USB port on the rear of the TV.
2. Enter the Interactive menu by pressing buttons in order:
→ 9 → ENTERE
3. Press the ▲ or ▼ button to select "Clone USB to TV", then press the
ENTERE button.
4. When the message "Clone USB to TV" is displayed, then press the
ENTERE button.
5. You can Make sure USB cloning behavior.
• In Progress: copying data to TV.
• Completed: copy finished successfully.
• Failed: copy did not finish successfully.
• No USB: USB is not connected.
• No File: There is no file to copy on the USB device. If you get a No File message, check the folder on your USB
device. The folder name should be T-KTMDEUCB.
✎ Activate copying from USB to TV by pressing ENTERE key for 5 seconds.
✎ The Hotel TV product family does not support the CLONE function between models that supports the
satellite / T2 operation and models that do not.
For fast, instant cloning during installation, insert a USB drive with master settings from the first TV and press the
Enter key for 5 seconds.
Pre-condition for cloning (check point)
‒ Cloning should be done between same model (same version).
‒ Before cloning, all displays should be updated at the latest version (same version).
9 → ENTERE
Clone TV to USB
Clone USB to TV
Setting Auto Initialize
Clone TV to USB
Clone USB to TV
MUTE → 1 → 1
Setting Auto Initialize
OFF
OFF
33
English