GE GFV40 Owner's Manual page 14

INSTALLING THE STACK BRACKET KIT
REMOVE THE DRYER
1
LEVELING LEGS
A. Carefully lay the dryer on its side. Use the packing
material so you don't scratch the finish on the dryer.
B. Use an open-end wrench or pliers to remove the
dryer leveling legs.
Back out and remove
all 4 leveling legs
INSTALL RUBBER PADS TO
2
DRYER BASE
Locate the 4 rubber pads in the parts package.
Remove the adhesive backing and firmly place over
each bracket where you removed the leveling legs.
14
Optional Instructions
Place pads over
all four leveling
leg brackets
INSTALL BRACKET TO DRYER
3
A. Align the holes in the left bracket with the holes in
the bottom left corner of the dryer. Use a Phillips
screwdriver to install the 2 #12 x 1" tapping screws.
B. Repeat the above step with the right bracket on
the bottom right corner of the dryer.
C. Set the dryer upright.
NOTE: Make sure to set the dryer on a piece of
packing material so the brackets that are attached to
the bottom of the dryer do not damage the floor.
Install
brackets
on bottom
back
4 PREPARE WASHER AND DRYER
A. Place the washer in the approximate location.
B. Make sure the washer is level. Refer to washer
Installation Instructions for details.
C. Reverse dryer door swing if desired. See Optional
Instructions in this manual for details.
NOTE: The washer door swing is not reversible.
Bottom
of dryer
49-90584