Onboard Super IO Device
Onboard FDC Controller
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use UMA
: Move Enter: Select +/-/PU/PD: Value
F5: Previous Values
Onboard SuperIO Device
Parameter
Onboard FDC Controller
Onboard Serial Port 1
Onboard Parallel Port
Parallel Port Mode
ECP Mode Use DMA
38
Phoenix - AwardBIOS CMOS Setup Utility
Onboard Super IO Device
[ Enabled ]
[ 3F8/IRQ4 ]
[ 378/IRQ 7 ]
[ SPP ]
3
F10:Save
F7: Optimized Defaults
Enables or disables the onboard floppy disk
drive controller.
This option is used to assign the I/O
address and interrupt request (IRQ) for
onboard serial port 1
This option is used to assign the I/O
address and interrupt request (IRQ) for the
onboard parallel port.
Enables you to set the data transfer protocol
for your parallel port.
SPP (Standard Parallel Port), EPP
(Enhanced Parallel Port), ECP (Extended
Capabilities Port) and ECP+EPP.
Select a DMA channel for the parallel port
when using the ECP mode. This field is only
configurable if Parallel Port Mode is set to
ECP. The available setting values are 3 and
1.
ESC: Exit
Description
Item Help
Menu Level
F1: General Help
Option
Enabled
Disabled
Disabled
3F8/IRQ4
2F8/IRQ3
3E8/IRQ4
2E8/IRQ3
Auto
Disabled
378/IRQ7
278/IRQ5
3BC/IRQ7
SPP
EPP
ECP
ECP+EPP
1
3
Chapter 2