Acer Aspire M3600 Service Manual page 43

Super IO Device (Press Enter): Scroll to this item and press <Enter> to view the following screen.
Onboard FDC Controller (Enabled): Select Enabled if your system has a floppy disk
controller (FDC) installed on the main board. If you install an add-in FDC or the system has no
floppy drive, select Disabled in this field.
Onboard Serial Port 1/2 (3F8/IRQ4/2F8/IRQ3): These options are used to assign the I/O
address and interrupt request (IRQ) for onboard serial port 1 and port 2.
Onboard Parallel Port (378/IRQ7): This option is used to assign the I/O address and
interrupt request (IRQ) for the onboard parallel port.
Parallel Port Mode (SSP): Enables you to set the data transfer protocol for your parallel port.
There are four options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port), ECP
(Extended Capabilities Port), and ECP + EPP.
ECP Mode Use DMA (3): When the onboard parallel port is set to ECP mode, the parallel port
can use DMA 3/1.
Chapter 2
Phoenix-AwardBIOS CMOS Setup Utility
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x
ECP Mode Use DMA
CIR Port Address
x
CIR Port IRQ
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
Super IO Device
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
[Disabled]
11
F7:Optimized Defaults
Item Help
Menu Level
35