Cleaning The Heat Pump Filter - Pelgrim PWD120WIT Detailed Instructions

CLEANING THE HEAT PUMP FILTER

Place an absorbent cloth on the floor in front of the dryer (possible
water spill).
36
Insert the heat pump foam filter back (which is placed inside
of dryer) (make sure the filter is inserted correctly into the
support bed; otherwise, heat exchanger may be clogged).
Close the exterior cover (push it upwards towards the
appliance until it snaps back into place). Clean the foam filter
at least after every five drying cycles.
1
Open the outer
cover (hold
the handle on the
left side and pull
downwards.
2
Use the handle
to remove the
heat pump foam
filter.
3
Remove the
heat pump foam
filter from its handle.
Use a damp cloth to
clean the heat pump
housing. Be careful
not to damage the
cooling system.
4
Wash the filter
under running
water. Dry the filter
before replacing it.