Prepare The Remote Control; Power On; Set The Clock - Philips BTM1560/12 User Manual

Prepare the remote
control
Caution
•
Risk of product damage! When the remote
control is not used for long periods, remove
the batteries.
•
Batteries contain chemical substances, so
they should be disposed of properly.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.

Power on

Press .
» The product switches to the last
selected source.
Switch to standby mode
Press again to switch the product to
standby with no clock display, or to
standby with clock display.
» The red standby indicator lights up.
•
In standby, you may press and hold
to toggle clock display on
or off.
Note
•
The product switches to standby mode
after 15 minutes inactive.
•
To achieve the efficient energy saving
performance, unplug any external
electronic device from the USB port when
the device is not in use.

Set the clock

1
In power on mode, press and hold
CLOCK for more than 2 seconds to
enter the clock setting mode.
»
or
2
Press /
hour format, and then press
» The hour digits begin to blink.
3
Press /
then press
» The minute digits begin to blink.
4
Press /
then press
» The clock is set.
Note
•
To view clock in power on mode, press
briefly .
•
In standby, you may press and hold
to toggle clock display on or off.
•
If clock display is turned on in standby,
power consumption increases.
is displayed.
to select 24H or 12H
to set the hour, and
.
to set the minute, and
.
EN
.
9