Remote Control - Onkyo TX-SR373 Operating Instructions Manual

1
1

Remote control

RECEIVER RECEIVER
1
BD/DVD BD/DVD CBL/SAT CBL/SAT STRM BOX STRM BOX
AUDIO SEL AUDIO SEL
LATE NIGHT LATE NIGHT
2
TOP MENU TOP MENU
3
QUICK MENU QUICK MENU
4
5
6
SURR SURR DSP DSP
TREBLE TREBLE
7
DISPLAY DISPLAY TUNING TUNING + EDIT EDIT SLEEP SLEEP
PRESET - PRESET PRESET + PRESET
8
TUNING -
TUNING BAND BAND
TUNER TUNER
RC-928R
As for operating other devices, the remote control codes for
the Onkyo products are preset. The settings cannot be
changed.
1
ÍRECEIVER
Switches the receiver between standby and on.
2
Input function buttons
Use to select the input source to this receiver
9
will enable you to control other Onkyo components with the
remote control.
10 3 USB
control buttons
USB
Use to control the
are not possible.
11
4
Receiver control buttons
Q
MENU) – Use to access the Audio options
(QUICK
(page 26).
– Press to access the Setup
– Use to return to the display immediately previous
when making settings
12
5 ENTER
///,
Use the arrow buttons when setting up your surround sound
system (page 29).
13
6
Listening mode and component control buttons
DIRECT
– Press to select Direct playback
STEREO
– Press to select stereo playback
SURR
– Press for standard decoding and to switch
between the modes of
(page 25).
DSP
– Switches between the various surround modes
(page 25).
7 BASS +/–, TREBLE +/–
Use to adjust Bass or Treble.
14
• These controls are disabled when the listening mode is set
to DIRECT.
15
• When the front speaker is set at SMALL in the Speaker
16
Setting (or automatically via the AccuEQ Room Cal. setup)
and the X.Over is set above 150 Hz, the subwoofer
channel level will be adjusted by pressing
(page 30).
(page 18). This
source. Operations other than USB
(page 29).
(page 25).
(page 25).
Pro Logic II and NEO:6
BASS +/–
6
Controls and displays
8 TUNER
control buttons
See Listening to the radio on page 22.
9 AUDIO SEL
Press to select the audio input signal of the component to
play back (page 18).
10 LATE NIGHT
Turns ON and OFF the LATE NIGHT function
11
M.OPT
Press to restore CD quality sound to compressed audio
sources (page 25).
12
Mutes/unmutes the sound.
13 VOL +/–
Use to set the listening volume.
14 SLEEP
Press to change the amount of time before the receiver
switches into standby (30 min – 60 min – 90 min – Off). You
can check the remaining sleep time at any time by pressing
SLEEP
once.
15 DIMMER
Dims or brightens the display. The brightness can be
controlled in four steps.
16
Switches the display of this unit. The listening mode, sound
volume or input name can be checked by selecting an input
source.
2
4
33
(page 26).