Golden MAXICOMFORT Orion Owner's Manual page 8

A D
uto rive with
1. Getting into your lift chair. While standing next to your chair, press button
(S7) and raise the chair to a height you can sit against. This height will vary
from person to person depending on the individual's needs. Raise the chair
high enough so you do not have to flop down into the chair. Flopping down
into the chair will damage it and could cause personal injury. Press
button (S9). As the chair continues downward, adjust yourself into a position
that is comfortable to you. Continue holding (S9) until chair is in the seated
position (chair firmly on the floor), then release the button. You can also press
buttons (S6, S8) and the chair will move to those positions.
2. Getting out of your chair. Press button (S7) and raise the chair to a height
that enables you to easily stand. Release the button. Return the chair to the
seated position (S9) (chair firmly on the floor) after getting out of the chair, so
children, pets or obstructions do not get under the chair. Repeat no. 1 when
you want to sit down.
3. To move into twilight (away from
wall) up and out. Press (S10) and hold it
until the chair reaches a position suitable
for you, then release the button.
4. To move out of twilight (towards the
wall) down and in. Press (S5) and hold it
until the chair reaches a position suitable
for you, then release the button.
Micro Adjustments
1. To recline the back of the chair, press
button (S1) and hold until the back reaches
the desired position. Then release the
button.
2. To bring the back of the chair to an
upright position, press button (S2) and
hold until the back reaches the desired
position. Then release the button.
3. To raise the foot rest and seat, press button (S3) and hold until the foot rest
reaches the desired position. Then release the button.
4. To lower the foot rest and seat, press button (S4) and hold until the footrest
closes. Then release the button.
Note: The motors are set to shut off when they reach their fully extended
or fully retracted position if the selected button is not released. If you
should go past your desired position, select the button to bring you back
to your desired position. You can repeat the process as often as you like.
t -C
wilight
8
o
ontrol perAtion