Golden MAXICOMFORT Orion Owner's Manual page 7

INSTALLATION MAXICOMFORT
1. Remove the transformer from the transformer box (located behind the lower
outside back) and install two 9 volt alkaline batteries into the sockets on the
transformer. Place transformer on the floor behind the chair.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and
Plug
To outlet
115-120V A.C.
3. Place the chair in the desired
position in the room, keeping it 24"
away from the wall. If placing the
chair into a corner, keep it 24" from
the wall as shown. See distance
chart below for your model.
Distance Required From Wall
When Reclined
Model Number
PR514-MLA
PR405-MLA
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against
it. Raise the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the
magazine pocket on the arm of the chair.
Note: 1AMP USB Charging Port located in the lift chair pocket, model
PR405 only.
USB Disclaimer: The supplied USB charging port is only intended to
be used with appropriate smart devices such as phones or tablets.
Please refer to device manufacturer's charging requirements before
using. Golden Technologies excludes liability for any damages or data
loss regarding the charging device on a computer or other electronic
device connected to the USB port.
WITH TWILIGHT POSITONING
connect the power cable from the chair into the transformer as
shown. Power cable is located under the chair attached to the
motor shaft with white zip tie. Remove zip tie, extend cable under
and out behind the chair.
L.E.D. light
DC Power
Transformer
Wall Corner
24 in.
21 in.
L.E.D. light
From motor
24"
24 in.
21 in.
7
Bottom view of
Transformer
Install two 9 volt batteries
in the transformer for bat-
tery backup (See page 12)
(batteries not included)
24"
Side
View
24"
Corner
Top
View