Advertisement
Instruction Manual
Bed Frame For Twin Mattress
Model M3KGT-5
Due to the presence of small parts during assembly, keep
out of reach of children until assembly is complete.
Model M3KGT-5 Sports Car Bed Frame
Read all instructions before assembly and use.
Keep instructions for future use.
ADULT ASSEMBLY REQUIRED
Lancaster, PA 17601
tradecraftspecialties@gmail.com
www.tradecraftspecialties.com
Revised 10/09/2017
1900 Alfa Drive
(717) 269-8934
Page
1 of 7
Advertisement
Table of Contents
Related Manuals for Tradecraft Specialties M3KGT-5
Summary of Contents for Tradecraft Specialties M3KGT-5
- Page 1 Due to the presence of small parts during assembly, keep out of reach of children until assembly is complete. 1900 Alfa Drive Lancaster, PA 17601 (717) 269-8934 tradecraftspecialties@gmail.com www.tradecraftspecialties.com Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 1 of 7...
- Page 2 ● Do not allow hanging, swinging, or leaning from or through any part of the bed or bed structure. General Specifications Assembled dimensions (approximate): 86" long, 39.5" wide, 24" high. Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 2 of 7...
- Page 3 We use low-odor, zero VOC paint where possible and do our best to keep unpleasant odors to a minium. Disassembly To disassemble, reverse order of steps for assembly. Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 3 of 7...
- Page 4 Parts List Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 4 of 7...
- Page 5 Step 2 - A: Loosely fasten side assemblies [A] to rear shelf support [G] using lag bolts [E] and flat washers [F], (1) lag bolt per side with a washer on each lag bolt. Do not yet fully tighten lag bolts. Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 5 of 7...
- Page 6 (1) screw at each end of support bar. Make sure support bar end is tight and perpendicular with side of bed. Start at rear of bed and work towards front. Leave 4.5” gaps between each support bar (approximately 7” center-to-center). Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 6 of 7...
- Page 7 Step 3 - R: Fasten footboard [J] to ends of panel supports using lag screws [E] with (1) washer [F] on each screw. Step 4: Tighten all hardware. Make sure all assembled parts are tight and secure. Page Model M3KGT-5 Sports Car Bed Frame Revised 10/09/2017 7 of 7...
Need help?
Do you have a question about the M3KGT-5 and is the answer not in the manual?
Questions and answers