Table of Contents
Advertisement
3-7
Installing the Mezannine Card
3-7-1 OCP 3.0
Use of the following type of OCP 3.0 NIC is recommended:
• OCP 3.0 SFF with Pull Tab
• OCP 3.0 SFF with Ejector Latch
Follow these instructions to install an OCP 3.0 mezzanine card:
1.
Remove the two screws securing the mezzanine card slot cover.
2.
Remove the slot cover from the system.
3.
Insert the OCP 3.0 mezzanine card into the card slot ensuring that the card is firmly connected to
the connector on the motherboad.
4.
Tighten the thumbnail screw to secure the OCP 3.0 mezannine card in place.
5.
Reverse steps 3-4 to replace the OCP 3.0 mezzanine card.
1
3
4
- 37 -
2
System Hardware Installation
Advertisement
Table of Contents
