TP-Link TL-WPA7617 User Manual page 12

Chapter 2
2 Check the new extender's Powerline LED
• If it is on, follow Step
• If it is off, follow Step
3 Add the new powerline extender to the existing powerline network by pairing two
powerline devices.
a . Press the Pair button on the existing powerline device for 1 second. The Power
LED starts blinking.
Note: If the Power LED does not blink, press the button again.
b . Within two minutes, press the Pair button on the new powerline extender for 1
second. The Power LED starts blinking. When the Powerline LED turns solid on,
the pairing process is complete.
Blinking
Existing
Powerline Device
4 Relocate the new extender to the Wi-Fi "dead" zone.
Note: A blinking Powerline LED indicates poor signal strength. Move the extender to another location.
A . Use the SSID (network name) and password on the on the label at the top of the
extender to connect to the internet.
C . If you cannot find the default SSID in your Wi-Fi network list, this may mean the
Wi-Fi Move feature has automatically copied over the existing wireless settings.
Existing Powerline Device
(For demonstration only)
4 > A.
3 and Step 4 > B.
Within 2 minutes
e
r l i n
w e
P o
New Powerline Extender
TL-WPA7617
. Is it on?
Blinking
On
New Powerline Extender
TL-WPA7617
Initial Use
10