Advertisement
III. BATTERY INSTALLATION
Requires 2 AA Alkaline batteries for the vehicle and
2 AA Alkaline batteries for the transmitter. Batteries not
included.
Vehicle
1. Use a screwdriver (not included) to unscrew the
power clip cover screw, remove the battery cover.
2. Install 2 AA Alkaline batteries (not included),
with polarity (+/-) as shown inside the battery
compartment.
3. Replace the battery door.
Transmitter
1. Remove the battery cover as shown.
2. Install 2 AA Alkaline batteries (not included),
with polarity (+/-) as shown inside the battery
compartment.
3. Replace the battery cover. Once the batteries are
installed the transmitter will always be "ON" and
will work automatically the moment you use it.
IV. QUICK TIPS
1. When your vehicle starts to lose power, it
may lose functionality or performance. It's
time for fresh batteries.
2. Your vehicle's running time may vary
depending on your driving style.
3. Radio interference can affect your
vehicle's performance. Interference can be
caused by other R/C vehicles running on the
same frequency, electrical wires, large
buildings, CB radios or other wireless
gear. Try to stay away from these!
4. Point your transmitter up - not down
toward your vehicle. If your vehicle gets
too far away, it won't work properly.
5. Don't drive your vehicle through water
or snow. If your vehicle does get wet,
wipe it with a towel and allow it to dry
completely.
6. Don't store your vehicle near heat or in
direct sunlight. Always turn switches OFF
and remove all batteries for storage.
1
4
5
2
3
6
Advertisement
