Wireless Speakers Connection - LG HT936TAW Owner's Manual

Wireless speakers connection

LED indicator of wireless receiver
LED Color Operation
Blue The wireless receiver is receiving
the signal of the wireless
transmitter.
Red The Wireless Receiver is in
standby mode.
Off (No The Wireless Receiver is turned
display) off.
Initial setting an ID of wireless
receiver
1. Connect the Wireless Receiver and the rear
speaker (right, left) with the speaker cables.
2. Connect the power cord of the Wireless
Receiver to the outlet.
3. Turn on the main unit and Wireless Receiver:
The main unit and wireless receiver will be
automatically connected.
"MATE OK" appears in display window.
Setting an ID of wireless receiver
When the unit is manufactured, the ID is already set.
If an interference occurs or you use a new wireless
receiver, an ID should be set again.
1. Turn on the main unit and turn off the wireless
receiver.
2. Press and hold Z (STOP) on the front of unit
and MUTE on the remote control. "REMATE"
appears in display window.
3. Turn on the Wireless Receiver. A new ID is set.
HT906TAW-PM_DARELLK_ENG_4729.indd 15
About Ferrite Core (for EMI only)
Be sure to attach the ferrite core to the speaker
cable (for connecting to this unit and wireless
receiver). This ferrite core can reduce noises.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
2. Wind the speaker cables once on the ferrite
core.
3. Close the ferrite core until it clicks.
Refer to the fig.3 and comment.
1
2
Rear of wierless receiver
3
(fig. 3)
Connecting 15
2
The length
here is as short
as possible.
2011-02-21 11:59:31