Table of Contents
Advertisement
36
General Cleaning
Before manually cleaning any part of the oven, be sure all
controls are turned off and the oven is cool.
Aluminum Foil and Oven Liners
Do not use oven bottom liners or use aluminum foil to
cover the oven racks.
Protective liners—Do not use aluminum foil to line the oven
bottom, except as suggested in the manual. Improper installation
of these liners may result in a risk of electrical shock, or fire.
Using a liner in the oven restricts the heat and air flow needed
to obtain the best possible cooking results for any oven.
During clean the oven temperature can become hot enough to
melt aluminum cooking utensils or aluminum foil if left in the
oven. This could result in permanent damage to the oven
interior and porcelain finish.
Replacing the Oven Lights
Replacing the Dual Left and Right Corner Oven Lights
There are two interior oven lights located at the rear of the oven
cavity and are covered with a glass shield. The glass shield
must be in place whenever the oven is in use
To replace the oven interior light bulb:
Be sure the oven is unplugged and all parts are cool before
replacing oven light.Wear a leather-faced glove for protection
against possible broken glass.
1.
Turn electrical power off at the main source or unplug the
appliance
2.
Remove interior oven light shield by turning a quarter turn
counter-clockwise.
3.
Replace bulb with a new T-4 type Halogen 25 watt
appliance bulb.
Figure 35: Oven light in rear of cavity
Do not allow your fingers to touch the new bulb when replacing.
This will shorten the life of the bulb. Use a paper towel or cotton
glove while handling the new bulb when installing.
4.
Replace glass oven light shield by rotating clockwise.
5.
Turn power back on again at the main source (or plug the
appliance back in).
6.
Reset the time of day on the clock.
Replacing the Dual Left or Right Side Oven
Lights
An interior oven light will turn on automatically when the oven
door is opened. The oven light may be turned on when the door
is closed by using the oven light switch located on the control
panel.
The lamp is covered with a glass shield. The glass shield can
be remove to be cleaned manually or to change the oven light.
To replace the oven interior light bulb:
Be sure the range is unplugged and all parts are cool before
replacing oven light. Wear a leather-faced glove for protection
against possible broken glass.
1.
Turn electrical power off at the main source or unplug the
appliance.
2.
To remove the glass shield, pull the back side of the shield
toward the inside of the oven in a manner to lift it up from
the oven side. The glass shield should come out easily by
pushing a little toward front of the wall oven (See
Figure
3.
Replace the Halogen appliance bulb.
(Figure
35).
Do not allow your fingers to touch the new bulb when replacing.
This will shorten the life of the new bulb. Use a paper towel to
cover the new bulb when installing.
4.
Replace glass interior oven light shield.
5.
Turn power back on again at the main source (or plug the
appliance back in).
6.
Be sure to reset the time of day on the clock.
Figure 36: Light shield (L) and Halogen bulb (R)
36).
Lift backside of
glass shield and
remove it.
Care and Cleaning
Halogen
Light Bulb
Advertisement
Table of Contents
