Table of Contents
Advertisement
Attaching the Stand (Type two) (C43J890DK* / C43J892DK*)
― Before assembling the product, place the product down on a flat and stable surface so that the screen is facing downwards.
: The product is curved. Placing pressure on the product when on a flat surface may damage the product. When the product is on the ground facing up or down, do not put pressure on it.
Caution
Hold the stand neck with both hands,
not one hand, to prevent it from falling
off and causing injury.
1 5
Push the COVER-CLEAN BACK STAND in
the direction as shown in the figure.
1 1
Place the stand neck on the monitor as
shown in the figure.
1 6
Stand up the monitor as shown in the
figure.
1 2
Fasten the screws at the top of the
stand neck.
1 7
Remove the package.
1 3
Insert the stand base into the stand
neck in the direction as shown in the
figure.
1 4
Assemble the COVER-CLEAN BACK
STAND to the stand neck as shown in
the figure.
21
Advertisement
Table of Contents
