Advertisement
REPAIRS (continued)
For a demonstration of good patching technique, please
view the How to Repair video on the instruction page of our
web site. There is a link at the bottom of every page at
SeaEagle.com or type "instructions" into the search box.
Warped Skeg or Skeg Base
If the skeg is bent from storage or use, heat it up with a hair
dryer and bend it back into shape. It will hold it's shape
after it cools. The same can be done with the skeg base. If
not folded properly, the base can get warped in storage.
Never hammer the skeg into a warped base as it will break
the skeg.
Leaking Drain Valves
If you suspect the drain valves are leaking they can be
tested by pouring some water in the boat and checking
under the boat for water dripping from the valves.
Flush any sand or debris from the threads. Check where
the caps screw into the floor that the O-rings are smooth
and without dents. If you see a dent in an O-ring, heat it up
with a hair dryer, and the dent will ease out and return to its
original shape. This also works if the base is bent or mis-
shapen.
OPTIONAL ACCESSORIES
Kayak Motormount
(OPTIONAL)
The motormount kit in-
cludes an aluminum
board, brackets and the
wooden motormount.
Simply install the motor-
mount to the aluminum
board using the brack-
ets, and align them with
the pre-drilled holes on
the aluminum boad.
Next, insert the board
through the D-Ring han-
dles on the back of your
kayak. You may find
that this is easier to do
when your kayak is fully
inflated. Push the motor
mount over until the
bracket meets the D-
ring handle.
12
OPTIONAL ACCESSORIES (continued)
QuikSail
(OPTIONAL)
Converts any kayak into
a sailing vessel. Easily
deploys in under one
minute, breaks down to
just 43" for convenient
storage in the bow or
stern and sails up to 45°
left or right.
Deluxe Fishing Seat
(OPTIONAL)
With a back height of
17" for superior back
support, our DFS sits
you 10" off of the floor
for greater fishing and
casting comfort. Inflates
and installs in the same
fashion as the smaller,
DKS seats.
Drop Stitch Footrest
(OPTIONAL)
The inflatable footrest
can be positioned just
about anywhere in the
kayak. To use, position
where you want it and
inflate. Air pressure will
keep it in place.
Double D-ring Strap
(OPTIONAL)
This nylon strap has a
D-ring at each end and
goes underneath the
drop stitch floor allowing
you to position and re-
position these D-rings
anywhere inside of your
kayak. Can be used for
tie-down points, Thigh
Straps and more!
Advertisement
