Cleaning And Maintenance; General Cleaning; Cleaning The Heating Element; Thermal Safety Switch - EuroLite N-250 User Manual

Hide thumbs

Table of Contents

Available languages

Maintenance conditions

There are no serviceable parts inside the device. Maintenance and service operations are only to be

carried out by authorized dealers. Should you need any spare parts, please use genuine parts.

Transport conditions

Prior to transportation, allow the machine to cool down and completely empty the fluid and water tank.

General cleaning

We recommend a frequent cleaning of the unit, in particular the output nozzle. Please use a soft lint-free and

moistened cloth for the outside of the unit. Never use alcohol or solvents! Do not allow the fog liquid to become

contaminated. Always replace the cap on the fog liquid container immediately after filling.

Cleaning the heating element

The heating element should regularly be cleaned every 40 operational hours in order to avoid clogging. It is

recommended to run a cleaning solution composed of 80% distilled water and 20% white vinegar through the

system.

Procedure:

• Fill cleaning solution into empty fluid tank. Run the machine several times in a well-ventilated room. The number

of repetitions depends on the pollution level of the vaporizing elements.

• After use, empty all remaining cleaner and rinse the tank thoroughly.

• The Eurolite fog fluids we recommend are non-hazardous to the environment and can be disposed of via the

sewage system.

Thermal safety switch

The machine is fitted with a thermal safety switch. In the unlikely event of overheating, the switch will automatically

interrupt the control circuit. If the thermal switch trips, disconnect the machine from the mains and let it cool down

(approx. 2 hours). Then press the thermo switch down and switch on the power again.

Fuse

The machine is fitted with a circuit breaker. In the unlikely event of overloading, the circuit breaker will

automatically trip. It can be reset by pressing the BREAKER button with the machine unplugged.

Storage

It is recommended to operate the machine at least once a month with a warm-up period and a few minutes of fog

emission. Prior to storage, run cleaning fluid through the system as described in the cleaning regimen above. This

will help avoid any particles condensing inside the pump or heater.