Better Homes and Gardens SAVANNAH BH17-021-199-21 Assembly Instructions Manual page 8

STEP 4
x 1 0
4 . 1 5 m m P a n
H e a d S c r e w
Begin by installing all of the screws along one
edge of the back panel. Next, using a square
pre-drilled holes
or tape measure, make sure that the case is
square. (if using a tape measure, the distance
from one corner, diagonally to the other corner
should be the same in both directions.) Install
the remaining screws, starting with the corners.
NOT TO SCALE. REFER TO PAGE 3 FOR ACTUAL SIZE HARDWARE.
1. Make sure the screws go through pre-drilled holes properly.
2. Do not over tighten screws.
8