Safety - Beko RDNE420K20X User Manual

Instructions for safety and environment
floor covers under the product.
This may cause risk of fire as a
result of inadequate ventilation!
Do not block or cover ventilation
holes. Otherwise, power
consumption may be increased
and damage to your product may
occur.
Do not connect the product to
supply systems such as solar
power supplies. Otherwise,
damage to your product may occur
as a result of the abrupt voltage
fluctuations!
The more refrigerant a
refrigerator contains, the bigger
its installation room shall be. In
very small rooms, a flammable
gas-air mixture may occur in case
of a gas leak in the cooling system.
At least 1 m3 of volume is required
for each 8 grams of refrigerant.
The amount of the refrigerant
available in your product is
specified in the Type Label.
The installation place of the
product shall not be exposed to
direct sunlight and it shall not be in
the vicinity of a heat source such
as stoves, radiators, etc.
If you cannot prevent installation
of the product in the vicinity of a
heat source, you shall use a suitable
insulation plate and the minimum
distance to the heat source shall be
as specified below.
- At least 30 cm away from heat
sources such as stoves, heating units
and heaters, etc.,
- And at least 5 cm away from
electric ovens.
Your product has the protection
class of I. Plug the product in a
Refrigerator / User Manual
grounded socket that conforms
with the Voltage, Current and
Frequency values specified in the
type label. The socket outlet shall
be equipped with a fuse with a
rating of 10 A – 16 A. Our company
shall not be responsible for the
damages that shall be incurred as
a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
The product's power cable must
be unplugged during installation.
Otherwise, risk of electric shock
and injury may occur!
Do not plug the product to loose,
broken, dirty, greasy sockets or
sockets that has come out their
seats or sockets with a risk of
water contact.
Place the power cord and hoses
(if available) of the product so
that they shall not cause a risk of
tripping over.
Penetration of humidity to live
parts or to the power cord may
cause short circuit. Thus, do
not use the product in humid
environments or in areas
where water may splash (e.g.
garage, laundry room, etc.) If
the refrigerator is wet by water,
unplug it and contact an authorized
service.
Do not connect your refrigerator
to power saving devices. These
systems are harmful for the
product.
1.6 Operational

safety

Do not use chemical solvents
on the product. These materials
contain an explosion risk.
5/40 EN