Table of Contents
Advertisement
Installation
A
For your safety, close the
water inlet tap completely
after the washing programme
is over.
Connection to the drain
Water discharge hose can directly be
connected to the drain hole or sink's
drainage. The length of this connection
must be min. 50 cm and max. 100 cm
from the floor. A discharge hose longer
than 4 meters will cause washing
performance to be affected.Attach the
water discharge hose to the drainpipe
without bending it. Tightly fix the water
discharge hose to the drainpipe in order
to prevent any dislocation of the water
discharge hose during operation of the
product.
C
Drainpipe must be connected
to the foul water system and
it should not be connected to
any surface water drain.
10
/44 EN
aquAvoid™ plus
The aquAvoid™ plus system protects
against water leaks that may occur
at the hose inlet.Water contact with
the valve box of the system must be
avoided to prevent damage to the
electrical system. If the aquAvoid™ plus
system is damaged, unplug the product
and call the Authorised Service Agent.
A
As the hose set contains
electrical connections and
assemblies, never shorten
or lengthen the hose with
extension hoses.
Adjusting the feet
If the door of the product cannot
be closed properly or if the product
wobbles when you push it slightly,
then you need to adjust the feet of the
product. Adjust the feet of the product
as illustrated in the relevant section.
Electrical connection
Before you insert the plug into the wall
socket make sure that the voltage and
the frequency shown in the rating label
corresponds to your electricity supply.
Dishwasher / User manual
Advertisement
Table of Contents
