Table of Contents
Advertisement
User checklist
If your cleaner is not working properly run through the
following checklist.
1.
Is there a working electricity supply to the cleaner?
Check with another electrical product.
2.
Is the dust container full or choked with fine dust?
To empty the dust container, see instructions on P6.
3.
Is the hose blocked?
To clear a blockage, see instructions on P7.
4.
Is there a blockage in the cleaner base?
To clear a blockage, see the instruction on P7.
5.
Are the filters blocked?
To clean filters, see the instruction on P6.
6.
Is the nozzle height set correctly?
To set the carpet height selector, see the instruction on p4.
7.
Are the brushes rotating correctly?
To check the brushes, see the instructions on p7.
8.
Has the cleaner overheated?
If so, it will take about 30 minutes to reset.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in working order, has not been assembled in
accordance with these instructions or has been used incorrectly. working order,
has not been assembled in accordance with these instructions or has been used
incorrectly.
Warning!
A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
imPOrTanT: Do not run cleaner over the supply cord as this could damage the
supply cord insulation.
imPOrTanT inFOrmaTiOn
Hoover Service
Should you require service at any time, please contact your local Hoover Service
Office.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Hoover's factories have been independently assessed for quality. Our products
are made using a quality system which meets the requirements of ISO 9001
gUaranTEE STaTEmEnT
The guarantee conditions for this appliance are as defined by our representative
in the country in which it is sold. Details regarding these conditions can be
obtained from the dealer from whom the appliance was purchased. The bill of
sale or receipt must be produced when making any claim under the terms of this
guarantee.
Subject to change without notice.
- 8 -
Quality
Advertisement
Table of Contents
