Table of Contents
Advertisement
Available languages
Available languages
E N G L I S H
Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Inserting and removing a drill bit (fig. A)
Keyed chuck
• Open the chuck by turning the sleeve (3)
counterclockwise and insert the bit shank.
• Put the chuck key (4) into each hole in the side of
the chuck and turn clockwise until tight.
• To remove the bit, proceed in reverse order.
Keyless chuck (option)
• Open the chuck by turning the sleeve (3)
counterclockwise and insert the bit shank.
• Tighten firmly by turning the sleeve clockwise.
• To remove the bit, proceed in reverse order.
en - 4
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
45
Cable rating (Amperes)
6
6
6
6
6
6
6
6
15
6
6
10
15
20
10
10
15
20
20
15
15
20
25
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
10
15
15
15
15
15
20
20
20
20
20
25
Chuck removal (fig. B & C)
Keyed chuck
• Open the chuck jaws as far as possible.
• Insert a screwdriver into the chuck and remove
the chuck retaining screw (5) by turning
clockwise as shown.
• Insert the chuck key (4) into one of the holes in
the side of the chuck and strike it with a hammer
as shown.
60
Keyless chuck (option)
6
10
• Open the chuck jaws as far as possible.
15
• Insert a screwdriver into the chuck and remove
20
the chuck retaining screw (5), if any, by turning
25
clockwise.
-
• Tighten an Allen key into the chuck and strike it
-
-
with a hammer as shown.
6
6
6
6
Instructions for use
15
15
• Be aware of the location of pipework and
20
-
• Apply only a gentle pressure to the tool.
Prior to operation:
• Insert the appropriate bit.
• Mark the spot where the hole is to be drilled.
Switching ON and OFF (fig. A)
• To run the tool, press the ON/OFF-switch (1).
• To stop the tool, release the switch.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
wiring.
Excessive force does not speed up
drilling but decreases tool performance
and may shorten tool life.
14
Advertisement
Chapters
Table of Contents
