Chamberlain RIFMS2 User Manual page 2

Programming Intercom
The intercom must be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Press and hold both buttons on the intercom for
5 seconds. An initial beep will be heard followed by a
second beep. The channel lights will flash. Within 10
seconds put the second intercom into Learn Mode
(refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.
Add to an Existing Network
Press and hold both buttons on the new intercom for
5 seconds. An initial beep will be heard followed by a
second beep. The channel lights will flash. Within 10
seconds put any networked intercom into Learn Mode
(refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
2
LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.