Table of Contents
Advertisement
EN
Receiver Installation (ARF Plus)
Afterburner Ring Installation (Sold Separately)
To add the optional Afterburner Ring.
An extension lead is already installed in the fuselage for the afterburner ring. The
end of the lead is taped under the vertical stabilizer mounting structure inside the
fuselage. It may be easier to locate and connect the lead by removing the EDF unit.
1. Remove the 2 screws (A) securing the vertical stabilizer (B) and remove the
vertical stabilizer.
2. Remove the 2 screws (C) holding the tailcone (D) and remove the cone.
3. Connect the afterburner connector to the preinstalled servo lead found under
the vertical stabilizer.
4. Apply contact cement (E) to the mating surface of the fuselage where the
afterburner ring (F) will fit.
5. Fit the ring to the fuselage.
6. Reinstall the tailcone and the vertical stabilizer.
7. Remove the battery hatch and locate the loose "LED" afterburner extension
plug, close to the receiver, and plug it into the other end of Y-Harness that is
plugged into channel 6.
The afterburner ring cannot be Y-Harnessed with the ESC (throttle channel). The
serial data stream will not allow the afterburner ring to operate correctly.
Transmitter Setup for Afterburner Ring
DX6e
1. Go to the SYSTEM SETUP
DX6 (Gen2)
2. Set CHANNEL ASSIGN (Model Setup, Channel Assign)
DX7 (Gen2)
DX8e
3. Select: RX PORT ASSIGNMENT
DX8 (Gen2)
DX9
4. Select the drop down: 6 AUX1:
DX10t
DX18
DX20
iX12
iX20
5. Change to: Throttle
NX6
NX8
NX10
Some of the terminology and function locations used in the iX12 and iX20
†
programming may be slightly different than other Spektrum AirWare
The names given in parentheses correspond to the iX12 and iX20 programming
terminology. Consult your transmitter manual for specific information about
programming your transmitter.
12
(Model Utilities)
†
†
:
radios.
™
A
C
D
F
F-16 Falcon 80mm EDF
B
E
Advertisement
Table of Contents
