Model Assembly (Continued); Pnp Receiver Selection And Installation - E-FLITE Conscendo Evolution 1.5m Instruction Manual

EN
Model Assembly
(Continued)
Wing Installation continued
1. Slide the wing halves together on the wing tube.
2. Install the plastic center cap on the center of the wing.
3. Connect the aileron servos to the Y-harness. The left and right aileron servos
can be connected to either side of the Y-harness.
4. Be sure not to pinch the wiring between the wing and fuselage
and when you install the wing, .
5. Tighten the four 12mm x 3mm machine screws to secure the
wing assembly to the fuselage.
6. Disassemble in reverse order.

PNP Receiver Selection and Installation

The recommended receiver for this aircraft is the Spektrum AR637T.
If you choose to install a different receiver, it needs to be a 4 channel or more
full range (sport) receiver. Refer to the manual of your chosen receiver for correct
installation and operation instructions.
AR637T Installation
1. Remove the hatch on the bottom of the fuselage.
2. Attach the appropriate control surfaces to their respective ports on the receiver
using the table at the right.
3. Using double-sided servo tape, mount the receiver to the flat area ahead behind
the ESC, as shown. The receiver should be mounted in the orientation shown,
parallel to the length of the fuselage, with the label facing down and the servo
ports facing the rear of the aircraft. The orientation of the receiver is critical for
all AS3X and SAFE technology setups.
® ®
CAUTION: Incorrect installation of the receiver could cause a crash.
6
Conscendo Evolution1.5m
1 = Throttle
2 = Aileron
3 = Elevator
4 = Rudder