JVC KD-X282DBT Instruction Manual page 40

Installation/Connection
Part list for installation
(A) Faceplate (×1) (B) Trim plate (×1)
(C) Mounting sleeve (×1) (D) Wiring harness (×1)
(E) Extraction key (×2)
Basic procedure
1 Remove the key from the ignition switch, then disconnect
the terminal of the car battery.
2 Connect the wires properly.
See "Wiring connection" on page 33.
3 Install the unit to your car.
See the following "Installing the unit (in-dash mounting)".
4 Connect the terminal of the car battery.
5 Press B SRC to turn on the power.
6 Detach the faceplate and reset the unit within 5 seconds.
(Page 4)
32 ENGLISH
KD-X282DBT_E_B5A-3845-00_EN_1st Draft.indd 32 KD-X282DBT_E_B5A-3845-00_EN_1st Draft.indd 32
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim
plate as illustrated
before fitting.
Installing the unit (without mounting sleeve)
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(commercially available).
Use only the specified screws. Using wrong screws might damage
the unit.
Data Size:
Book Size:
Do the required wiring.
(Page 33)
Dashboard of
your car
Bend the appropriate tabs to hold the
sleeve firmly in place.
Removing the unit
B6L (182 mm x 128 mm)
7/9/2021 4:37:54 PM 7/9/2021 4:37:54 PM
B6L (182 mm x 128 mm)