JVC KD-X282DBT Instruction Manual page 26

Bluetooth®
(for KD-X282DBT)
Make a call to a registered number
1
Press to enter Bluetooth mode.
2 Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO PRESET" appears if there is no contact stored.
Bluetooth mode settings
1 Press and hold .
2
Turn the volume knob to select an item (see the following table), then
press the knob.
3 Repeat step 2 until the desired item is selected/activated or follow the
instructions stated on the selected item.
4 Press to exit.
To return to the previous setting item, press
[BT MODE]
[PHONE SELECT] Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
" " appears in front of the current playback audio device.
[AUDIO SELECT]
• You can connect a maximum of two Bluetooth phones and one Bluetooth
audio device at a time.
[DEVICE DELETE] 1 Turn the volume knob to select a device to delete, then press the knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
[PIN CODE EDIT] Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
Repeat step 1 and step 2 until you finish entering the PIN code.
3 Press the volume knob to confirm.
18 ENGLISH
KD-X282DBT_E_B5A-3845-00_EN_1st Draft.indd 18 KD-X282DBT_E_B5A-3845-00_EN_1st Draft.indd 18
[RECONNECT]
[INITIALIZE]
[INFORMATION]
Bluetooth compatibility check mode
You can check the connectivity of the supported profile between the
Bluetooth device and the unit.
• Make sure there is no Bluetooth device paired.
1 Press and hold
"BLUETOOTH"
.
PHONE"
2 Search and select the name of your receiver ("KD-X282DBT") on the
Default: [XX]
Bluetooth device within 3 minutes.
3 Perform (A), (B) or (C) depending on what appears on the display.
(A) "PAIRING"
(B) "PAIRING"
(C) "PAIRING": Operate the Bluetooth device to confirm pairing.
[ON]: The unit is automatically reconnect when the last connected
Bluetooth device is within the connectable range. ; [OFF]: Cancels.
[YES]: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; [NO]: Cancels.
[MY BT NAME]: Displays the name of your receiver ("KD-X282DBT"). ;
[MY ADDRESS]: Shows address of this unit.
.
"CHECK MODE" appears. "SEARCH NOW USING
"PIN IS 0000" scrolls on the display.
"XXXXXX" (6-digit passkey): Ensure that the same
passkey appears on the unit and Bluetooth device, then operate the
Bluetooth device to confirm the passkey.
"PIN IS 0000": Enter "0000" on the Bluetooth device.
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
7/9/2021 4:26:58 PM 7/9/2021 4:26:58 PM