Maintenance; Warranty - Dimplex DX 521 Installation And Operating Instructions Manual

Free-standing convector
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 5
DX 521, DX 522 T
5. Overload protector
For your safety, the heating device is equipped with
an overload protector. If the air circulation is inter-
rupted (e.g. due to the air grille being covered or
closed), the device switches off automatically.
In this case, the power supply to the heating device
should be disconnected for a few minutes (switch off
the fuse) to allow the device to cool down sufficiently.
Before recommissioning the device, remove the rea-
sons for the overload protector being triggered.

6. Maintenance

The device must be disconnected from the mains and
allowed to cool down before maintenance. Clean the
outside of the device using a soft, damp cloth. Do not
use scouring powder or furniture polish as this may
damage the surface.
Dust which gathers inside the device can be removed
from the outside using a vacuum cleaner.
10. Technical data
Order code
Connection voltage
Power consumption
Protection class
Degree of protection
Heating levels
Heat output
Nominal heat output
Minimum heat output (guide value)
Maximum continuous heat output
Additional power consumption
At nominal heat output
At minimum heat output
In standby mode
Type of heat output/room temperature control
Mechanical thermostat for room temperature control
Dimensions (width x height x depth) (with / without feet)
Weight
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
95326 Kulmbach
www.dimplex.eu
Pnom
Pmin
Pmax,c
Elmax
Elmin
elSB
Phone: +49 9221 709 700
Fax: +49 9221 709 701
E-mail: elektroheizung@dimplex.de
7. Faults
If the heating device is not emitting any heat, check
the following points:
Has the heating level been selected?
Has the thermostat been set to the desired tem-
perature?
Has the overload protector been triggered? See
chapter 5.
Is the fuse in the switch box switched on?
If you cannot remedy the fault, please contact your
electrical retailer. The retailer will require the product
number (E no.) and the production date (FD) of the de-
vice. This information is listed on the type plate.

8. Warranty

This product is supplied with a two-year warranty ac-
cording to our terms of guarantee.
9. Recycling
Do not dispose of the device with general
household waste. Take the device to the
available collection points at the end of its
service life.
Unit
DX 521
kW
kW
kW
kW
kW
kW
kW
kW
°C
mm
kg
2203/A
DX 522 T
1/N/PE 230-240 V ~ 50 Hz
2.0
I, with protective conductor
IP20
1.2 / 2.0
2.0
2.0
1.2
1.2
2.0
2.0
0.0
0.0
0.0
0.0
0.0
0.0
7 - 35
585 x 443 x 233 / 104
3.75
4.25
English
EN-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dx 522 t

Table of Contents