Operating The Dishwasher - Bosch Ascenta Evolution SHE6AF0 Use And Care Manual

Operating the Dishwasher

SHE6AP
To start the dishwasher:
Door must be closed. Press the "ON/OFF" button.
The Countdown Display and one of the Wash Cycle
LEDs will be lashing. You can now select a wash
cycle.
Press the "<" or ">" button to select the desired wash
cycle.
Select the "Half Load" or "Delay Start" features if
desired at this point.
In addition to your Wash Cycle selection, for small loads of
lightly soiled dishes press the "Half Load" button. This will
save energy and water.
If you would like to delay the start time of the dishwasher
press the "DELAY" button until the desired delay time
(1-24 hrs.) shows in the Countdown Display window.
Press the "START" button to begin the cycle (Wash
Cycle Indicator Light will stop lashing)
Close the door to begin the cycle
NOTE: Rinse Agent Indicator Light will be illuminated if
the unit needs Rinse Agent.
To cancel a cycle:
Press and hold the "START/RESET" button until the
countdown display reads "0:01".
Wait until the display reads "0:00" and turn the unit
OFF.
Open the door and press the "ON/OFF" button.
You are now ready to start a new cycle.
To enter the options mode(rinse agent setting, extra
dry heat, cycle completion signal):
Door must be closed. Press the "ON/OFF" button to
turn the unit on.
20
The countdown display and one of the Wash Cycle
LEDs will be lashing.
Press and hold down the ">" button, then press and
release the "START/RESET" button. Now release the
">" button.
The "Sanitized" LED will be lashing. You are now in
the options setup mode.
Press ">" to select the option you would like to
adjust.
If the display shows "d:00" or "d:01" you can turn the Extra
Dry Heat ON or OFF.
If the display shows between "r:00" to "r:06" you can adjust
the amount of rinse agent dispensed.
To set the amount of Rinse Agent:
NOTE: If your glasses have spots on them, you need more
rinse agent. If your glasses have streaks, you need less
Rinse Agent.
Follow the prior instructions to enter "options" mode.
With the display window showing "r:00" - "r:06":
Press the "<" button to change the amount of rinse
agent dispensed.
r:00 --> Rinse Agent OFF
r:03 --> Medium amount of rinse agent dispensed
r:06 --> Highest amount of rinse agent dispensed
Press START to save your settings.
To turn Extra Dry Heat on or of:
With the countdown display showing "d:00" or "d:01":
Press the "<" button to turn Extra Dry Heat on or of. 0
d:00 --> Extra Dry Heat is OFF
d:01 --> Extra Dry Heat is ON
Press START to save your settings.