Operating The Dishwasher; To Cancel Cycle; To Set Amount Of Rinse Agent - Bosch Ascenta Evolution SHE6AF0 Use And Care Manual

10
Depending on your model you will either have 4, 5 or 6 wash
cycles.
To start the dishwasher:
Open the Door. Press the "ON/OFF" button.
One of the Wash Cycle LEDs will be lashing. You can
now select a wash cycle.
Press the "<" or ">" button to select the desired wash
cycle.
Press the "START" button (LED stops lashing)
Close the door to begin the cycle
NOTE
1. Rinse Agent Indicator Light will be illuminated if the
unit needs Rinse Agent.
2. If you close the door without pressing the start button
the unit will beep.
To cancel a cycle:
Open the dishwasher door just far enough to expose
the control panel. Be careful of hot water splash out!
WARNING
You could be seriously scalded if you allow hot water to
splash out of the dishwasher. OPEN THE DOOR CAREFULLY
during any wash or rinse cycle. Do not fully open the door
until water noises have stopped.
Press and hold the "START/RESET" button until the
"Active" indicator light goes out.
Close the door and wait for about 1 minute for the
dishwasher to drain.
Open the door and press the "ON/OFF" button.
You are now ready to start a new cycle.
To enter the options mode(rinse agent setting, extra
dry heat, cycle completion signal):
Door must be open. Press the "ON/OFF" button to
turn the unit on.
One of the Wash Cycle LEDs will be lashing.
Press and hold down the ">" button, then press and
release the "START/RESET" button. Now release the
">" button.
18

Operating the Dishwasher

SHX4AP, SHX5AL, SHX6AP
The "Clean" and one other LED will be lashing. You are
now in the options setup mode.
Press ">" to select the option you would like to adjust.
If the "Clean" and "Rinse Agent" LED are lashing you can
adjust the Rinse Agent settings.
If the "Clean" and "Sanitized" LED are lashing you can set
the Extra Dry Heat.
To set the amount of Rinse Agent:
NOTE: If your glasses have spots on them, you need more
rinse agent. If your glasses have streaks, you need less
Rinse Agent.
Follow the prior instructions to enter "options" mode. With
the "Clean" and "Rinse Agent" LEDs lashing:
Press the "<" button to change the amount of rinse
agent dispensed.
0 LEDs lashing --> Rinse Agent dispenser is OFF
1 LED lashing --> Lowest amount of rinse agent
2 LEDs lashing --> Medium amount dispensed
3 LEDs lashing --> Highest amount of rinse agent
Press "START" to save your settings.
To turn Extra Dry Heat on or of:
With the "Clean" and "Sanitized" LEDs lashing:
Press the "<" button to turn Extra Dry Heat on or of.
The wash cycle LEDs will illuminate when you press
"<".
0 LEDs lashing --> Extra Dry Heat is OFF
1 LED lashing --> Extra Dry Heat is ON
To set the Cycle Completion Signal:
With the "Clean" , "Sanitized" , and "Rinse Agent" LEDs
lashing:
Press the "<" button to change the cycle completion
tone level. The wash cycle LEDs will illuminate when
you press "<".
0 LEDs lashing --> Cycle Completion Signal is OFF
1 LED lashing --> Low tone level
2 LEDs lashing --> Medium tone level
3 LEDs lashing --> Highest tone level
Press START to save your settings.