Table of Contents
Advertisement
Installation
3
To make the product ready for use, make
sure that the electricity, tap water supply
and water drainage systems are appropriate
before calling the Authorised Service Agent.
If they are not, call a qualified technician
and plumber to have any necessary
arrangements carried out.
C
Preparation of the location
and electrical, tap water and
waste water installations at the
place of installation is under
customer's responsibility.
B
Manufacturer shall not be held
responsible for damages arising
from processes carried out by
unauthorised persons.
A
Prior to installation, visually
check if the product has any
defects on it. If so, do not have
it installed. Damaged products
cause risks for your safety.
C
Make sure that the water inlet
and discharge hoses are not
folded, pinched or crushed
while pushing the product into
its place after installation or
cleaning procedures.
When placing the product, pay attention not
to damage the floor, walls, piping, etc. Do
not hold the product from its door or panel
to move it.
Appropriate installation
location
Place the product on a solid and flat
•
floor that has sufficient load carrying
capacity! The product must be installed
on a flat surface in order for the door to
be closed comfortably and securely.
Dishwasher / User's Manual
Do not install the product at places
•
where temperature may fall below 0ºC.
Place the product on a rigid floor. Do
•
not place it on a long pile rug or similar
surfaces.
B
Ensure the power cable does
not get trapped under the
product.
Make sure that you select a location
•
that will allow you to load and unload
the dishes in a fast and comfortable
manner.
Install the product in a place close
•
to the tap and the drain. Select the
installation location by considering
that it will not be changed after the
connections are made.
Connecting water supply
Do not use old or used water inlet
•
hose on the new product. Use the new
water inlet hose supplied with the
product.
Connect the water inlet hose directly
•
to the cold water tap. Permitted water
temperature up to 25°C. Pressure
coming from the tap should be
minimum 0.3 and maximum 10 bars. If
the water pressure exceeds 10 bars, a
pressure relief valve should be installed
in between.
Open the tap completely after making
•
the connections to check for water
leaks.
A
For your safety, close the water
inlet tap completely after the
washing programme is over.
9 / 43 EN
Advertisement
Table of Contents
