Kenwood KMM-BT506DAB Instruction Manual page 43

Installation/Connection
Part list for installation
(F) Film antenna (×1) (G) Amplifier unit (cable with
Determine the antenna installation position
• The direction of the film antenna (F) changes depending on whether the film antenna (F) is
installed on the right side or left side.
• Be sure to check the installation location of film antenna (F) before installing. Film antenna
cannot be re-pasted.
• Separate from other antennas by at least 100 mm.
• Do not paste the amplifier unit (G) on the ceramic line (black part) around the front glass.
Because there is not enough adhesion.
Installing the antenna on the left side
Ceramic line (black part)
Earth sheet*
* Paste the earth sheet of the amplifier unit (G) on the metal part of the front pillar.
(H) Cable clamper
booster, 3.5 m) (×1) (×3)
(I) Cleaner (×1)
Installing the antenna on the right side
CAUTION
When installing the antenna cable inside the front pillar with the air bag installed
• The front pillar cover is secured with a special clip
which may need to be replaced when it is removed.
Contact your vehicle dealer for details on removing
the front pillar cover and availability of replacement
parts.
• Install the amplifier unit (G) above the air bag so that
it does not obstruct the operation of the air bag.
Installation overview
The antenna should be installed
Earth sheet*
on the passenger side for safety.
Clip
Front pillar
Air bag
35
ENGLISH