Remote Control; Replacing The Fuse - Beamz S1500LED Instruction Manual

REMOTE CONTROL

Adjuster:
The Interval regulator adjusts the time between discharges when the timer function is engaged.
The Output regulator controls the volume of the fog produced. The range is from 0% - 100% of
maximum output.
Adjust the Duration regulator of each fog emission.
Buttons:
The yellow TIMER button controls the timer function. Depress the button to activate. When
activated, the yellow light will turn ON. Adjusting the interval knob will determine the time
between fog output. The duration of output is set at 15 seconds. The volume can be adjusted
using the volume knob to control the amount of fog produced.
The red CONTINUOUS button sets the machine to constant fog production. To activate this
function, depress the red button. The volume knob can be used to regulate the volume of the
steady stream of fog produced.
The green MANUAL button will produce a continuous blast at maximum volume while the button
is held down. When released, the manual function stops and the machine will return to the
previous setting; timer, continuous, or stationary.
Note: The duration of manual fog output is based on the capability of the fog machine.
CLEANING
After 40 operating hours, the smoke machine must be cleaned to avoid deposits in the machine, pump and heater.
Procedure:
Remove smoke fluid from the tank, fill "Beamz smoke machine cleaner fluid" (item no. 160.670) into empty tank.
1.
2. Switch the power on and wait until smoke machine is warmed up.
3. Press on the button of remote control and pump the liquid through the machine.
4. Perform the above operation until the tank is empty.
5. Fill the tank with Beamz smoke fluid.

REPLACING THE FUSE

If the fuse is defective, replace the fuse with a fuse of the same type and value. Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
ACCESSORIES
High quality smoke fluid on water basis, specially designed for Beamz smoke machines guarantees a trouble-free use.
5 liter packaging, ref. no. 160.582
1 liter packaging, ref. no. 160.643
Run clean procedure in a well-ventilated area!
5