Table of Contents
Advertisement
NME1854R & FME2404R
REMOVAL AND REPLACEMENT: Water Seal
To Remove the Water Seal:
REMOVAL OF THE
(Assuming all steps to remove the auger have
WATER SEAL
been performed.)
1. The gear motor/evaporator assembly will have
to be exposed (if not yet done).
2. Remove the 4 hex head cap screws holding the
evaporator to the gear motor assembly. Lift the
evaporator up and off of the gear motor.
3. Remove the snap ring or wire retainer from the
grove under the water seal.
4. Pull or drive out the lower half of the water seal.
To Replace the Water Seal:
1. Lubricate the water seal with water, and push
the water seal into the bottom of the evaporator
slightly past the grove for the snap ring.
2. Replace the snap ring and pull the water seal
down against it.
3. The part of the water seal that rotates with the
WATER SEAL
auger must also be replaced. Remove the old part
from the auger and clean the mounting area.
4. Place a small bead of food grade silastic sealant
(such as 732 RTV or Scotsman part number
RETAINING
19-0529-01) on the area of the auger where the
RING
water seal is to be mounted.
5. Carefully push the water seal (rubber side
against the auger shoulder and the silastic.)
CAUTION
Do not get any silastic onto the face of the seal.
6. Allow the auger and seal to air dry until the
silastic is dry on the surface.
7. If the original water seal was leaking, it would
be a good idea to inspect the interior of the gear
motor.
PLACE A BEAD OF
FOOD GRADE
SEALANT HERE
January 2000
Page 31
Advertisement
Table of Contents
