Installation; Notes For Installation; Leg Adjustment - LG GL40SGP Owner's Manual

INSTALLATION

Notes for Installation

Install the product on a solid and flat area.
• If the product is installed on an uneven floor, it can
cause vibration and noise causing the product to fall
resulting in injury.
• If the product front or rear are not level, put a solid
object (such as a ruler) underneath, fix it with tape,
and push the product to level it horizontally.
Avoid placing the unit near heat sources, direct sunlight
or moisture.
Install accessories such as ice cube box, etc., in their
proper places. They are packed together to prevent
possible damage during shipment.
Connect the power supply cord (or plug) to the outlet.
Don't double up with other appliances on the same
outlet.
Product with handle shall be located at least 55 mm from
the wall on the hinge side to open door by 90°.
The warm air under and behind the product must be
able to escape or power consumption will increase.
Climate Class
The appliance is designed to operate at the limited
range of ambient temperature, depending on climate
zones. Do not use the appliance at the temperature over
the limit. Climate class of your appliance is indicated
on the label with technical description inside the fridge
compartment.
Class Symbol
Extended
temperate
Temperate
Subtropical
Tropical
Extended
temperate
SN-T
-Tropical

Leg Adjustment

To avoid vibration, the unit must be leveled.
If required, adjust the leveling screws to compensate for
the uneven floor.
The front should be slightly higher than the rear to aid in
door closing.
Leveling screws can be turned easily by tipping the
cabinet slightly.
Turn the leveling screws counterclockwise (
raise the unit, clockwise (
Ambient
temperature
range ºC
SN +10 – +32
N +16 – +32
ST +16 – +38
T +16 – +43
+10 – +43
) to
) to lower it.
11