Table of Contents
Advertisement
Flaw compensation [PIX OFF]
Flaws in the displayed camera image are corrected. Up to 16 points can be corrected.
Follow the procedure below.
"SPECIAL SETUP" screen
**SPECIAL SETUP**
...
...128
CHROMA GAIN
|
...
... 32
AP GAIN
|
...
... 32
PEDESTAL
|
-
+
PIX OFF
COMMUNICATION COAX
CAMERA RESET
PUSH SW
SER.NO. XXXXXXXX
RET TOP END
Step 1
Move the cursor to "PIX OFF" and press the setting button.
→ The "PIX OFF" screen appears.
Step 2
Select a number (1 to 16) with which a pixel compensation point is registered and press the setting button.
→ The pixel compensation positioning screen appears.
Step 3
Use the up, down, right, and left buttons to move the crosshair cursor to the center of the flaw to be corrected and press the setting
button.
→ The flaw is corrected and the pixel compensation point is registered. The "PIX OFF" screen appears again. "*" is attached at the
right side of the number when registration is completed. The coordinate is expressed in figures.
Note:
• To clear the registered pixel compensation point, move the cursor to the number with which the target pixel compensation point
is registered on the "PIX OFF" screen and press the setting button. The pixel compensation positioning screen appears, and then
hold down the right and left buttons for more than 2 seconds simultaneously. The "PIX OFF" screen appears, the pixel compensa-
tion point is cleared, and "*" at the right side of the number disappears.
"PIX OFF" screen
**PIX OFF**
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
000 000
RET TOP END
Pixel compensation positioning screen
23
Advertisement
Table of Contents
