Alarm Table; Recommendation In Case Of No Use Of The Appliance - Whirlpool W7 931T OX H 3 User Manual

Alarm table

ALARM TYPE
Door open alarm.
Temperature alarm.
Temperature alarm.

Recommendation in case of no use of the appliance

In the event of non-use of the applicance
Disconnect the appliance from the power supply, empty it, defrost it (if necessary) and clean it.
Keep the doors slightly ajar to let air circulate inside the compartments. By doing this, you avoid the development of mould
and bad odours.
In the event of an interruption to the power supply
Keep the doors closed so the food stays cold for as long as possible. Do not re-freeze food that has partially defrosted. If there is
a prolonged power cut, the black out alarm may also activate (in products with electronics).
9
SIGNAL
The acoustical alarm is
activated and the light
blinks, display flash the
set temperature in the
refrigerator.
The alarm sounds and
TEMPERATURE ALARM
flashes on the display ("A1"
is displayed instead of the
FREEZER temperature).
The alarm sounds and
temperature alarm flashes
on the display ("A2" is
displayed instead of the
FREEZER temperature).
CAUSE
The refrigerator door has
remained open for more than
two minutes.
The temperature inside
the freezer is too high.
The freezer will maintain a
temperature of around 0°C
so that the food will not
refreeze, allowing you to
eat it within 24 hours or to
refreeze it after it has been
cooked.
The temperature of the
freezer is dangerously high:
the food inside must not
be eaten. The freezer will
maintain a temperature of
approximately -18°C.
Use & Care guide
CURE
The buzzer will stop sounding
when you shut the door.
To switch off the buzzer, open and
close the appliance door or press
the + and – freezer temperature
adjustment buttons once. Press
these buttons a second time
to display the set value on the
freezer display, switch off the
TEMPERATURE ALARM LED and
restore normal operation.
To switch off the buzzer, open and
close the appliance door or press
the + and – freezer temperature
adjustment buttons once. Press
these buttons a second time
to display the set value on the
freezer display, switch off the
TEMPERATURE ALARM LED and
restore normal operation.